Difference between revisions of "Orange Pi Zero"
Jump to navigation
Jump to search
| Line 71: | Line 71: | ||
== External Links == | == External Links == | ||
* [https://linux-sunxi.org/Xunlong_Orange_Pi_Zero linux-sunxi.org board page] | * [https://linux-sunxi.org/Xunlong_Orange_Pi_Zero linux-sunxi.org board page] | ||
| + | * [https://www.armbian.com/orange-pi-zero/ Armbian page] | ||
| + | * [https://github.com/hyphop/miZy miZy Minimalistic OS] | ||
Revision as of 06:17, 21 July 2020
Orange Pi Zero is a small headless ARM computer.
Related: Orange Pi R1
Board
Upper side
| # | Component |
|---|---|
| 1 | 26-pin GPIO |
| 2 | Serial port: GND, RX, TX (left to right) |
| 3 | RJ45 Ethernet port |
| 4 | USB 2.0 port |
| 5 | 13-pin expansion port |
| 6 | WiFi antenna |
| 7 | XR819 WiFi controller |
| 8 | Pulse H1102NL Signal Transformer for the Ethernet port |
| 9 | Allwinner Technology H2+ SoC |
| 10 | 256/512 MB DDR3 SDRAM (256 MB in the photo) |
| 11 | micro-USB port (power and data) |
| 12 | ? LED |
| 13 | Power LED |
Bottom side
| # | Component |
|---|---|
| 1 | USB 2.0 port |
| 2 | RJ45 Ethernet port |
| 3 | 26-pin GPIO port |
| 4 | 13-pin expansion port |
| 5 | 2 MB SPI Flash 25L1606E |
| 6 | microSD card slot |
GPIO
- Supports GPIO, I2C, SPI, UART
- Pinout diagram
- Resources: Python GPIO library
Peripherals
- USB Bluetooth dongle (e.g. RTL8821CU) (not supported by the built-in module)
- USB Wifi dongle (e.g. RTL8821CU)
- to access the 5 GHz band (not supported by the built-in module)
- for packet sniffing or network proxy (not supported by the built-in module)
- I2C OLED display SSD1306
- to show the system status (CPU usage, IP address etc.)
- Resources: Rust SSD1306 library, Python OLED library
